10pcs Automatic Tracker Single Axis Solar Tracking Module Search Light Solar-Powered Automatic Tracker Board

Sensor BlocksParameterName: Single-axis light tracking boardSize: 35*16*1.2mmVoltage: 5-5.5VDC<;1.5AInterface: Power + - Motor MPrinciple: Use an obstruction on the photoresistor. When the light strikes the obstruction to form a shadow, and the light on one side forms a difference with the other side, the motor is controlled to find the balance point, that is, the center of the light .Line length: 15CMThe power supply uses a 5-5.5V DC power supply with a current of less than 1.5A.The motor uses a geared motor. The slower the speed, the better. The owner uses "JGY370 6V". When the power supply is 5V, the load is not heavy and the speed is stable. If the motor speed is too fast, it may cause the motor to align with the center of the light , but swings left and right, but does not shake. This circuit uses a short delay of anti-shake.When the motor and the board are connected, the positive and negative poles are not divided. When the motor is found to rotate in the opposite direction to the light , the motor line can be changed.The power supply must be regulated to 5.5-5.5V and cannot be directly connected to the solar panel.As shown in the figure, the photosensitive probe is on the same plane, and the small solar panel shade is used above. When the light intensity of the left probe is greater than the right side, the motor turns left until the two probes balance the value. The size of the shade is related to the angular accuracy of the light . It's to cover both probes at the same time.The tracking angle accuracy is related to the probe placement position, angle, and shade

• Sensor Blocks