Adjustable Clamp-on gate hinge pair

Effortlessly hang gates on pipes with these clamp-on, adjustable gate hinge pairs, featuring an optional J bolt. No welding or drilling required, making installation quick and simple. Customize your order with or without J bolts and choose between one-way or two-way bands. Accommodates 5/8" or 3/4" diameter J bolts. Each kit includes galvanized components, such as one-way or two-way brace bands, carriage bolts, hex nuts, and weld tabs, with J bolts included if selected. Sold in pairs to hang one gate. Installation involves measuring, marking locations, assembling brackets, and securing the gate. *Gate clamp not included.

• Kit Contents: 4 one-way brace bands, 4 carriage bolts, 8 hex nuts, 2 weld tabs, 4 two-way brace band pairs, 4 carriage bolts, 8 hex nuts, 2 weld tabs
• Initial Setup: Measure and mark locations for post j bolts, ensuring ground clearance for gate swing
• Assembly: Attach carriage bolt to band and j-bolt plate, then repeat for other ends and assembly
• Two-Way Band Installation: Position assemblies on post at marked height, open center hole on preferred swing side, attach other halves of band
• One-Way Band Installation: Slide brackets over post to marked height, open center hole towards gate direction
• Secure Bands: Tighten outside nuts to clamp bands to post
• Install J-Bolts: Thread nuts and washers onto bolts, insert into plate hole, adjust for gate leveling
• Attach Gate: Place gate female clamp into bottom j-bolt assembly, lift gate, slide up clamp into j-bolt, and tighten
• Final Adjustments: Secure clamps and make final adjustments to gate swing