Dyson DC15 End Cap Left Side

The Dyson DC15 End Cap Left Side 909549-03, holds one part of the brush bar in place inside the vacuum. This cap contains the end cap, bearing, spacer, spring, and fastener. When you are standing behind the vacuum, the end cap will be located on the left side. This end cap is also the one that is attached to the smaller brush bar roller.

To remove or replace the DC15 End Cap no tools are required, only a coin. Following these simple steps will have your end cap changed in less than two minutes.

• Turn off and unplug your DC15 vacuum
• Locate the correct end cap to remove
• Place the coin inside the fastener and turn it to unlock it
• Turn the end cap 90 degrees
• Pull the end cap from the vacuum, the brush bar may come along with it
• Place the correct end of the brush bar into the new end cap and reinstall it on to the DC15

Genuine Dyson End Caps are built to fit perfectly with your Dyson vacuum. Generic end caps have been reported to not fit properly to the cleanerhead of the vacuum.

The Dyson DC15 End Cap is compatible with the following DC15 models: All Floors, Animal, Full Kit, HSN Exclusive, Multi Floor, Total Clean.

Alternate part number:909549-01, DY-909549-01, DY-909549-01, DY-909549-03, DY-909549-03.

MPN: 909549-03