Inception Designs Paintball Tank Standard Output 0-1400psi Pressure Tester w/On/Off ASA

EZ Pressure Tester for paintball marker tanks and HPR's outputting up to 1400psi. This is the standard (STD) option. Use it to set your output pressure and to check for performance to ensure that the regulator isn't creeping (which can be very bad for a paintball gun and damage seals/solenoids inside the gun). Easy "EZ" operation. Simply screw tank or HPR into the bottom of the tester and then close the side lever. Pressure will read on the gauge immediately with your tank. With an HPR you need to turn on the air supply to the HPR. Press the button to release the lever and degas the pressure gauge. Repeat to check for consistency or leave it pressurized and watch the gauge to make sure the pressure isn't slowly increasing (creep). Designed to use the minimum amount of air from your tank as possible so you don't waste air/gas while testing and setting up your equipment at home. Pressure gauge style may vary from shown. **Tank not included**

• Easily check the output pressure of your paintball tank to ensure the regulator isn't creeping.
• The on/off ASA allows for easy tank removal and installation.
• Designed to use the minimum amount of air from your tank as possible so you don't waste air/gas while testing and setting up your equipment at home.