Joint shafts puller separator universal | Bowlift

Material: Carbon steel, total length: 250mm, width: 140mm, maximum CV joint diameter: 0.8 cm.

Time-saving as well as no damage to axle parts due to hammer and chisel. Easier and safer handling than with hammer, etc.

For the installation and removal of wheel bearings and wheel hubs, pulling of constant velocity joints on the front drive shaft.

For the installation of drive shafts, replacement of rubber boots or joints.

Ensure that a vehicle elevated is sufficiently supported with axle stands. Suitable for all common vehicle types.

- Drive shaft separation tool      
- for pulling the constant velocity joints on front drive shafts
- for the installation of drive shafts, replacement of rubber boot or joint
- tool width (inside): 99 mm
- tool length (inside): 204 mm
- time-saving as well as no damage to axle parts due to hammer and chisel
- suitable for Audi, Seat, Skoda, VW, and many other common vehicle types.
- tool in high-quality execution

Scope of delivery:
1x puller for drive shafts
Instructions for use