LumaFuse TPE-SEBS 1300 95A, Soft Flexible 3D Printing Filament, 1kg Spool, Dimensional Accuracy +/- 0.02 mm, Compatible with Most FDM Printers (Natural, 2.85mm)

This TPE-SEBS 95A is a soft material that is ideal for prototyping where rubber-like or elastomeric properties and durability are required. It has a Shore A hardness of 95, making it slightly firmer than TPE-SEBS 1300 85A, but still flexible enough for a wide range of applications. TPE-SEBS 95A is non-hygroscopic, meaning it does not absorb moisture, and is durable with repetitive motions. It is also resistant to chemicals, oils, and acids, making it a versatile material for a variety of industries. This material is easy to print, and can be used for a wide range of products, including medical devices, automotive parts, and consumer goods. Recommended Print Settings: Print Temperature: The optimal printing range is 230° – 270°C Bed Temperature: A bed temperature of 50°C to 70°C will provide the best adhesion during printing. Printing Speed: Base printing speed of 25 mm/s Infill speed of 15-25 mm/s Wall speed of 15-25 mm/s Initial layer speed of 15-25 mm/s Cooling: For best results, do not use a cooling fan while printing with TPE-SEBS. Bed Adhesion: Use a brim while printing on clean glass or a PEI sheet. No glue or extra adhesion method is necessary. Other Tips: If the material starts to short feed or bind up in the extruder, turn down the feeder wheel tension. It is recommended to start with as little tension as possible. Using a PTFE or fluoropolymer-lined tubing will help with printing. Using this type of tube will allow the print temperature to be lower. Disclaimer: Due to the large variety of printers and part geometries, the given process parameters are a guideline.