Speedway Motors Centered Ford 9-Inch Rear Axle Housing Kit w/ 52-Inch Width, 3" O.D. Reinforced Axle Tubes, Fabricated Steel Center Section, Includes Third Member Studs and T-Bolts

Looking for a budget-friendly, rock-solid foundation for your custom rear suspension? Look no further. Our fabricated steelCompatible with Ford 9 inch axle housings feature all-new components for maximum durability. It’s an evolution of the rugged and reliable 9 inchCompatible with Ford platform. Designed with the Builder in Mind This housing is pumpkin-centered with uniform-length axle tubes, side-to-side. So mounting suspension brackets, especially on triangulated 3-link and 4-link systems, is much easier. Unlike factory stamped housings, these fabricated plate-steel center sections provide a wide, flat surface for easy bracket attachment. Note that the pumpkin-centered design will offset the pinion yoke about 1" to the passenger side. Axle tubes are 3” O.D. with a 3/16” wall thickness. Heavy-wall tubes, along with a larger center section, significantly reduce distortion during welding of rear-link brackets or spring pads. Billet steel “New BigCompatible with Ford” (Torino) style bearing ends are fixture-welded (3.150” O.D. bearing, with 2.50” axle flange offset). Improved Design for Greater Durability In addition to the heavy-duty bearing ends, the axle tubes are supported with bracing inside the large center housing. This reduces flex in the rear end housing, which is something you won’t find on stamped factory 9 inch housings. Plus, gears stay well-lubed and run cooler thanks to a large-capacity fabricated center (holds more gear oil than stamped housings). Axle is vented on the driver’s side. Yet, with improved durability, our fabricated axle housing is on average 2 pounds lighter than stock style housings of the same size! Add your choice of axle shafts and third member (sold separately), and you are ready to roll. Equip your race car, hot rod or 4X4 withCompatible with Ford 9 inch parts from Speedway Motors to ensure there are no weak links in your driveline combination. Total wheel-to-wheel mounting surface width is 52" (from hub-to-hub)

• Durable Steel Construction: Built from 3" O.D. axle tubes with 3/16" wall thickness and internally reinforced for reduced flex, ensuring long-lasting strength and stability.
• Fabricated Center Section: Features a welded steel center section for enhanced durability and a larger oil capacity to keep gears cooler during operation.
• Billet Steel Bearing Ends: Equipped with "New Big Compatible with Ford" (Torino) style billet steel bearing ends for added strength, supporting a wide range of brake kits with a 2.50" axle flange offset.
• Centered Pumpkin Design: The housing's centered pumpkin simplifies suspension mock-up and ensures balanced axle tube lengths for easy bracket installation on custom rear suspensions.
• Complete Kit for Easy Installation: Includes third-member studs and 3/8" T-bolts for bearing retainer plates, making it a budget-friendly solution for race cars, hot rods, and off-road vehicles.